Kidco HEARTHGATE G70 User Manual download pdf (Page 3)

Removing or adding sections:

Note: Always begin separating gate from

either end. At the juncture of every section is

a removable, vertical bar.

To remove vertical bar, lift up on bar (5), while

sliding it out of lower hinge groove (6a.). Pull

bar down and out of cone (6.).

Lift off end section. If gate is now appropriate

length, go to step 8.

If additional section/s are required, go to

steps 11 & 12.

Depending on number of sections removed,

you will end up with one of two configurati-

ons at the end of gate (diagram 8 or 9).

Remove hinge cap (H) from bottom of original

end section. A screwdriver may be used to

help pry it off. Place cap over top hinge on

what is now the end piece.

Place spare hinge cover (G) over bottom

hinge. Go to step 10.

Assembly

5.

4

7.

6.

6a.

8.

H

I

G

5

Unpack your folded HearthGate™ on a

stable surface, making sure handle is on top.

Each corner is connected by plastic, inter-

locking hinges.

How to adjust the sections:

A spring is fitted in all cones which delib-

erately creates tension when adjusting.

At corner, lift up slightly on section with hinge

teeth facing down (1) while gently pressing

down on connected section (2). Rotate sec-

tions to desired position. (3). Release to lock

into place.

Note: Each hinge adjusts from 0˚ to 270˚ in

10˚ increments.

Position HearthGate™ to desired shape,

taking into account recommended 20” mini-

mum distance described in ”Important

Notes” on page 2. It may be necessary to

remove or add section/s to gate to fit your

application.

If making no changes, see ”Installation” steps

13 to 23.

If removing sections, see ”Assembly” steps 5

to 10.

If adding sections, see ”Assembly” steps 5 to

7.

Unpacking

1.

2.

3.

4.

1.

3.

2.

2a.

Lift

Down

Hinge

Removable cone

Removable cap

Cones Cones Removable cone

Removable cap

1 2 3 4 5 6

Comments to this Manuals

No comments